Walkthroughs

The camera can work with Node-RED and MQTT requests to communicate with other devices. The MQTT requests are used to get information, trigger the camera, or send information. Step 1 : The camera's IP address must be in the same range as the de...

Order the Required Serial Converter Purchase the RS485 to RS232 Serial Converter from [this link] . This device facilitates the conversion from RS485 signals, originating from the camera, to RS232. Connecting the Serial Converter to...

Adding Images for Training Step 1 : To connect to the network cable, first, locate the Ethernet port on your camera and connect one end of the network cable to it. Then, connect the other end of the cable to your router or switch. To log into ...

This section outlines the process for changing the recipe in the camera using PLC logic. Each step and corresponding action are detailed to ensure proper integration and functionality. Note : Make sure that the Recipe switch is not always ...

This example shows you how to set up a single recipe that can inspect different parts, angles or views without changing to other recipes.  There are a variety of reasons to do this, but two primary use cases: 1 - when there isn't enough time b...

Visit this page and verify you have followed all the steps and can’t use the usb-c port for communication. The camera not connecting with the configured IP When connecting your computer to the camera, it's' important to ensure both...

Link for the recipe Step 1 : To start a new segmenter model, you need to click on the "new recipe" button. Once you've clicked this button, you'll be prompted to name the model and choose the recipe type to be "segmentation." After you've do...

The camera can work with Node-RED and TCP to communicate with other devices. It's quite simple; the steps are: Step 1 : - The camera's IP address must be in the same range as the device it is interacting with. Step 2 : - A communication port...

Connect the camera to the PLC of your choice by following this article . Program the logic using a similar example Camera Triggering and Status Monitoring This section explains the process of triggering the camera and monitoring i...

The camera can work with Node-RED and MQTT requests to communicate with other devices. The MQTT requests are used to get information, trigger the camera, or send information. It is possible to trigger the camera using MQTT request, sending a message...

Download the sample recipe here Step 1 : To create your first new Classifier model, you must navigate to your all-recipes page and select "New Recipe". After that, you will need to click on the "Edit" button to initiate the process of creating y...